DIGO Products - SCOURING PLASTER COARSE

Scouring Plaster Coarse

DIGO SCOURING PLASTER COARSE

Product
Scouring Plaster Coarse is a solvent-free plaster for indoor use having a very beautiful structure, without mineral binders. It consists of an alkali-resistant, solvent-free and plasticizer-free acrylic dispersion, fine and course fillers and pigments.

Specific use
Scouring Plaster Coarse is suitable for any sound even surface on indoor walls and ceilings including cement, cellular concrete, chipboard, gypsum board and fixed layers of paint.

Characteristics
It is optimally breathing, shock-resistant, elastic, optimally adhesive and is easy to apply.

Colour
Available according to an elaborate colour spectrum.
Various lots can show small differences in colour. In order to prevent colour differences, it is advised to order the total quantity required for a project. Always mix different lots with each other.

Processing temperature
Do not use at a surface and ambient temperature below + 5°C.

Method of application
Scouring Plaster Coarse is applied with a stainless steel trowel or spraying equipment (e.g. funnel pistol). When using a trowel, Scouring Plaster Coarse must be applied at grain thickness. Abrade trowel marks. When using spraying equipment, spray until an even structure is obtained.

Consumption
1.06 kg per mm² per layer / 8 mm² per bucket of 17 kg.

Packing/Contents
In plastic buckets of 8 and 17 kg.

Surface
The surface must be dry and free from dust, grease and powdery coats of paint (wipe-resistant, whitewash coats). Powdery surfaces must be pre-treated with Undercoating solvent-free. See separate product information sheet.
Always pre-treat the surface in colour with Primer. See separate product information sheet.
Surfaces that can cause discoloration, pre-treat with Renovation Pre-spread. See separate product information sheet.

Storage
Protect against heat and frost.

Remark
It can be cleaned with all kinds of cleaners except solvents. Scouring Plaster Coarse can be painted over. Digo ornamental plasters must always be applied with stainless steel tools.
In the case of strong wind and bright sunlight, precautions against fast drying must be taken.